The Spiral Bevel manufacturer---GEEPRO MECHINERY will give you a brief introduction about preheating process used by CNC cutting machine.
Compared with Processing enterprises, the use of CNC cutting machines is extremely frequent, and it is precisely because of frequent use that the maintenance and inspection of CNC cutting machines are more important.
Importantly, the CNC cutting machine is an automatic cutting equipment with high efficiency and high intelligence. The following is based on years of actual production and operation.
For the majority of users and friends, I will explain some "preheating" matters that need to be paid attention to before using the CNC cutting machine, including the inspection and maintenance procedures of the equipment:
1. Check the clamping block, steel belt and guide wheel for looseness and loose steel belt.
2. Check whether all transmission parts are loose, check the gear and rack meshing condition (Condition), and adjust if necessary.
3. Check whether there is garbage at the main air inlet, and whether each valve [ ] (function: control component) and pressure gauge work normally. With the development of the modern mechanical processing industry, the cutting machine has continuously improved the quality and precision requirements of cutting.
The requirements for high production efficiency, lower production costs, and highly intelligent automatic cutting functions are also increasing. Xiaolongmen] CNC cutting machine Usually the CNC cutting system is based on the pre-programmed processing program (commonly used drawing software
AOTOCAD) to automatically process the machined parts. We put the machining process route, process parameters, tool motion trajectory, displacement, cutting parameters (spindle revolutions, feed, back-cut amount, etc.) and auxiliary
Function (tool change, spindle forward rotation, reverse rotation, cutting fluid on.off, etc.), according to the command code and program format specified by the CNC cutting system, write a processing program list, and then record the content of the program list on the control medium. (such as perforated paper
tape, magnetic tape, magnetic disk, magnetic bubble memory), and then input into the numerical control device of the numerical control machine tool, thereby directing the machine tool to process the parts.
4. Check whether all pipe joints are loose and all pipes are not damaged. Tighten or replace as necessary.
5. Loosen the tightening device (device), push the pulley by hand, whether it can come and go freely, if there is any abnormal situation (Condition), adjust or replace it in time.
6. Inspect the strong electric cabinet and the operating platform, check whether the fastening screws are loose, and use a vacuum cleaner or a blower to clean up the dust in the cabinet. Portable CNC cutting machine also known as trolley CNC cutting
machine or micro CNC cutting machine. From the perspective of model characteristics, the trolley cutting machine has the characteristics of high-speed and high-efficiency CNC cutting machine, and its processing accuracy is also much higher than that of ordinary hand-held or copying equipment. It is by virtue of the above characteristics that the car
Type CNC cutting machine is the most widely used type of cutting machine in the domestic market, and its market share reaches more than half. Check for loose terminals.
7. Inspect the performance of all buttons and selector switches, replace the damaged ones, and then draw a comprehensive inspection (jian ce) graphic to inspect the accuracy of the machine.
Favourite our page to keep getting more technical information about Spiral Bevel Cutting.Feel no hesitation to contact us(terry@geepromachinery.com)
